MacDon M200 Manual do Operador descarregar pdf (Página 101)

HEADER OPERATION - D SERIES

Form 169017 / 169087 / 169095 99 Revision C

6.5.8 KNIFE SPEED

The ideal cutting speed of the knife should be

such that a clean cut is achieved. Crop types and

conditions usually influence the knife and forward

speeds.

The Windrower Control Module (WCM) reads a

code from the header that determines the knife

speed range and the minimum speed when the

header is first attached to the windrower.

The desired speed can be programmed on the

CDM, and is stored in the WCM memory so that if

the header is detached and then re-attached to

the windrower, the knife will operate at the original

set-point.

If no header code is detected, the CDM displays

NO HEADER, and the knife speed reverts to a

range from 0 - 1400 strokes per minute and the

operator can then pre-set the speed.

NOTE

The knife speed cannot be programmed

outside the range specified for each header.

HEADER

DESCRIPTION

KNIFE SPEED *

[Strokes Per Minute

(SPM)]

TYPE SIZE (FT) MINIMUM MAXIMUM

Draper DK 15

1500**

1900**

Draper DK 20 and 25 1400 1700

Draper DK 30

1200

1600

Draper DK 35 1500

Draper DK 40 1100 1400

Draper SK 20 and 25

1200

1500

Draper SK 30 1450

Draper SK 35 1100 1400

Draper SK 40 1050 1300

* Suggested Overload Setting - 75% of Knife Speed.

** Grass Seed - 1400 to 1950.

Display and set knife speed “on the go” as follows:

CAUTION

Check to be sure all bystanders have cleared

the area.

#### = STROKES

PER MIN

HEADER ENGAGED

PRESS

PROGRAM/SELECT

DISPLAY SHOWS

#### KNIFE SPM

DONE

SPEED

O.K.?

YES

ON CDM PRESS

LEFT ARROW o

RIGHT ARROW

DISPLAY

SLOWER

FASTER

PROGRAM / SELECT

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 233 234

Comentários a estes Manuais

Sem comentários

MacDon M200 Manual do Operador Página 101

Comentários a estes Manuais

Manuais e produtos relacionados com Trator MacDon M200