MacDon M200 Manual do Operador descarregar pdf (Página 115)

HEADER OPERATION - R SERIES

Form 169017 / 169087 / 169095 113 Revision C

g. Disconnect center-link as follows:

MECHANICAL LINK - M150

1. Loosen nut (E), and rotate barrel (F), to

relieve load on link.

2. Remove cotter pin on pin (G), and remove pin

to disconnect from header. Reinstall pin in

header.

3. Tighten nut (E) against barrel (F). A slight tap

with a hammer is sufficient.

HYDRAULIC LINK - M200 STD, M150 OPTION

1. Activate HEADER TILT cylinder switch on

GSL to release load on center-link cylinder

(H).

2. Lift hook release (J), and lift hook (K), off

header pin.

NOTE

If optional center-link lift cylinder is installed,

lift release (J), and then operate the link lift

cylinder from the cab to disengage the

center-link from the header.

h. Disconnect header drive hydraulics (L) and

electrical harness (M). Refer to the R80 Header

Operator’s Manual.

i. Slowly back windrower away from header.

j. Reinstall pins (A) in header boots (B).

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 233 234

Sem comentários

MacDon M200 Manual do Operador Página 115