MacDon M200 Manual do Operador descarregar pdf (Página 95)

HEADER OPERATION - D SERIES

Form 169017 / 169087 / 169095 93 Revision C

j. Disconnect center-link as follows:

MECHANICAL LINK - M150

1. Loosen nut (J), and rotate barrel (K), to relieve

load on link.

2. Remove cotter pin on pin (L), and remove pin

to disconnect from windrower. Reinstall pin in

header.

3. Tighten nut (J) against barrel. A slight tap

with a hammer is sufficient.

HYDRAULIC LINK - M200 STD, M150 OPTION

1. Start engine, and activate header tilt cylinder

switch on GSL to release load on center-link

cylinder.

2. Disconnect center-link by lifting release (M),

and lift hook (N) off header.

NOTE

If optional center-link self-alignment kit is

installed, lift release (M) and then operate

the link lift cylinder with REEL UP switch on

GSL to disengage the center-link from the

header.

k. Slowly back windrower away from header.

NOTE

If hay conditioner is installed, watch

clearances on both sides.

l. Reinstall pin (A) into header leg, and secure with

hairpin.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 233 234

Sem comentários

MacDon M200 Manual do Operador Página 95